Nice! I hope it’s not too hot when using it. I once made a case that wasn’t able to sustain the temperature.

With polar coordinates and Fourier transforms, you can draw the outlines of tons of figures. But you can’t go back. Imagine that you can go with your pen around the center in only one direction, but any distance from the center.

Yes. https://en.m.wikipedia.org/wiki/Polar_coordinate_system

Since this curve is cyclical, you can do it [-infinity ; +infinity] and it’s the same curve again and again.

Study suggests people make smelling sounds out of their arse.

They need a cloud connection for the setup, but there is a “LAN only mode” (there are still some messages yet). There is also a new X1E (enterprise edition) that is said to be totally offline if needed.

What the actual fuck.

Nice !

I would go with wood filament.

Oh crap. You are right. Now I feel angry if this is fake data.

It’s way more exhaustive actually ! https://books.google.fr/books?id=7mWeBQAAQBAJ&pg=PA97&hl=fr&source=gbs_selected_pages&cad=1#v=onepage&q&f=false

I was maintaining a custom autoexec.bat just for TIE Fighter.

From my point of view : it has a hudge ecosystem with tons of robust libraries. This does not make it perfect, but for an industrial point of view, you don’t look for new shiny clean things. (My point of view is 15 years old yet…)

I wanted to know the date of this comic. It was issued in Eightball #5, February 1991.

I just measured it and the overhang behind is half the bed and half the infamous cable. You need around 60cm between the front feet and the wall behind, for the cable not to be torn when the bed is all the way to the back.

The bed goes back and forth. On the back, you need the place since there is the infamous cable that should not be torn. On the front, the bed can go over the void. There is no need for a 70 cm large table, maybe 50cm with overhang.

It’s a mess. I have the A1 with AMS and it takes way more space than I wanted. The coreX with AMS are way more compact.

Edit.
Wide 80cm (with the poop chute on the left and the AMS on the right) Depth 70cm (with all the cables and the bed going back and forth) Height 60cm with the top roll

I would like to get one for our club but I can’t understand the wide variety of prices. $150 ? $500 ? $2000 ? $10000 ? $75000!! ? What’s the cheapest that is not a pain to use ?

What slicer is it ? I will check if it is possible to set no purge at all in BambuStudio - since I have an AMS lite.

It looks feasible with a purge multiplier set to 0. https://forum.bambulab.com/t/setting-an-unbeatable-record-no-flush-at-all/51052/4

I say to people : if you’re interested in 3D printing, you need two hobbies. 3D printing and anything else. The second hobby can be repairing things, a sport (spearfishing for me), board games, electronics, etc.

I started with a 100€ very small 3D printer for years (Tina2) and that was so worth it. Now I have a Bambulab with AMS and it’s night and day.

Yes. It breaks points.

I agree with the other comments. Yet, it’s a beautiful design. What software do you use ?