This is a pretty accurate summary from my experience. The only thing I’d add is that (from what I’ve read at least) some form of ‘smart’ album functionality is high on the priority list and shouldn’t be too much further down the line. It may be a more advanced customizable logic type of solution (again from what I’ve read) but the functionality of putting person(s) ‘x’ into album(s) ‘y’ (or similar) should be achievable.

Rofl this is great 😂

There was a study I read not too long ago that found the pre-movie anti piracy warning actually acted sort of reverse psychology on men, causing them to actually pirate more (as opposed to women). There have definitely been some gender-correlations in certain studies.

Honestly embarrassed to admit I’ve somehow never seen this one, but what a great clip lol

It’s fast.

Idk what your connection looks like, but I have to agree that site feels insanely fast. Everything other than the store page click-to-full-load for me was probably ~1/3 of a second. Even the store page for me only took a second or so.

Those are definitely good points too for sure!

This is sorta where I’m at. It’s not an apples to apples thing I get that, and while I don’t have a Prusa their standing in the 3d printing community is straight up legendary I know.

Wish it were a hair cheaper, because $1,300 assembled with enclosure kit (to make it as close to, say, X1C as possible) is still a bitter pill when only $200 more gets you abrasive printing ability, larger build volume, faster still, 4 color MMU, etc.

There is the quality angle, and the angle that a Prusa is conceivably infinitely repairable…which is a big deal. Just wish it were a few hundred cheaper to sort of compensate or allow for some of those upgrades.

Ooooph. Owning both a modded to the nines Ender 3 v2 and a vCore 3.1, there’s a part of me that wants to add the simplicy and MMU functionality of the X1C to the mix at some point…but this is uhhhhhhh scary. No thank you lol!!

This is awesome!! Nice work!

This 1000% lmao