You must log in or register to comment.
Do these come flat packed is that what the tool is for or do you form the whole thing first then use the tool to bend?
Looks like stamped or laser cut pieces that then need bending in the 3rd dimension.
Then soldering a coaxial connector or wire to each half to finish them.
I have no idea if this is a clever bypass around expensive commercial offerings, a clever waste of time that barely improves over doing it by hand, or somewhere in between, but it sure looks like a nice design and print.
It’s an automation step for a small scale factory
Yeah, definite neato factor but by eyeball at least I feel like I could do that bend by hand within a mm tolerance of this. Hard to imagine this precision is needed. Makes sense if mass producing these I guess.
This is a workshop for combat FPV drones, so precision is extremely important.
Dunno how to feel… Excited because it looks cool or sad that it will be used to kill someone. The world has gotten depressing
Interesting. Important for balancing? Or does the signal reception really depend on that much precision? I’m Suprised to learn that either way.
They have to operate at very long distances in an electronic-warfare saturated environment. Even the tiniest imperfections can be the difference between life and death.
And in this case you want death!
It’s for bulk building drones you have into the faces of occupiers, good enough is necessary perfect is not.
I think the black thing they show at the end is the usual tool to do it, this just looks like 20 extra needless steps.
I make a lot of stuff and I don’t think I could bend it that precisely by hand. Also I would take much much longer.
What am I looking at here? What are these antennae used for?
They’re popular with drone pilots, here’s some old school website about them
I’m not a radio guy, but for a drone antennae, wouldn’t you want vertical range rather than broadside range?
No, yagi directionals point at the drone broadside.
Here’s the only thing you need to know: radio is black magic.
A drone operator usually is not standing directly under the drone, so no. Or alternately, the drone if probably further away from you horizontally than vertically during most of its operation.
One interesting thing here is that, for a given altitude, the antenna gain will be higher the further away the drone is.
it it for sharing or just showing off?
These look like the little flying sensor balls from Twister.
