Riveting!
I work in a manufacturing environment and keep all the weird anomalies that turn up in our hardware inventory. I have screws and carriage bolts with either half-formed or non-existent threads, keps nuts without the built-in washer, fiberlock nuts without the nylon, washers that didn’t get the center hole stamped through all the way, screws with off-center heads, Phillips screws with a ghost of where the Phillips hole should be, zinc-plated screws that only got half-dipped, a pop rivet that had the pin pressed cross-wise through the shank, and my favorite piece is a ball bearing that was packaged with a bee nestled inside the hole.
Things I’d like to put in a sturdy balloon or wrap in aluminum foil and blast out of a canon for $200 Alex!
Are you able to share pics of your collection?
I’d be interested to see, too!
My favorite one that I have found was a tape measure with exactly one error. The 2’ 0.5" mark was marked one sixteenth off. The entire rest of the tape measure was accurate.
This, friend, is the fodder of which Dull Men’s Club is made. You cannot merely mention this collection; to not show it would be cruel.
Spiraled out of control
/thread
Look how dull that screw is, it’s perfect
I say attempt a friction weld.
I’d say this is fastenating but obviously it’s not!
Someone at the factory accidentally disabled hyperthreading. You only get a core.
Nailed it.
You can’t just post lewds to Dull Men’s Club!
Put some threads on! Geeze!
I didn’t think it was possible but you just put a new spin on screwing.
That’s not a screw, it’s a Phillip’s head nail.
Actually made me laugh out loud. Thank you. I’m stealing this if I ever get the chance.
I tried to install a luggage rack on my car and the screw holes for the cover plates weren’t tapped, I feel your pain. Didn’t matter though because the cover plates didn’t align anyways so just left them off instead of tapping the holes myself
