Hello fellow withprinters. Whats happening here? Stringing is not the problem, if i print string tests, they are good. Its only in holes, the walls wont stick. Any suggestions for a fix?
Edit: Found the problem. The temperature sensor was faulty. Changed it and now everything is fine.
Correct. How do i fix it?
Print a bit hotter and a bit slower to improve layer adhesion
You could try turning up your extrusion and temp a little bit. Pushing more material should give added smoosh and better adhesion. I’d make a small model with the same feature I’m having trouble with to test settings with, then try the whole print with the new settings and cross my fingers.