Hello fellow withprinters. Whats happening here? Stringing is not the problem, if i print string tests, they are good. Its only in holes, the walls wont stick. Any suggestions for a fix?
Edit: Found the problem. The temperature sensor was faulty. Changed it and now everything is fine.
Kind of looks like the wall isn’t adhearing to layer below it and the nozzle is pulling it around
Correct. How do i fix it?
Print a bit hotter and a bit slower to improve layer adhesion
You could try turning up your extrusion and temp a little bit. Pushing more material should give added smoosh and better adhesion. I’d make a small model with the same feature I’m having trouble with to test settings with, then try the whole print with the new settings and cross my fingers.